Replaceable and adjustable anti-wear skid in four positions to vary the cutting height.
3P arch made of welded carpentry, able to withstand all the stresses of a heavy series shredder, 3P attachment in cat. II and cat. III.
The rear idle roller can be configured in 6 distinct positions, which allow you to vary the volume and geometry of the box. There are three height positions away from the rotor (to increase the cutting volume) and three height positions near the rotor (to decrease the cutting volume), this allows you to configure the machine according to the quantity of material to be cut (and therefore the power required) and the size you want to obtain.
The system with double parallelogram arm allows you to obtain a total lateral translation of about 150 cm, while in the rest position the machine is centered with respect to the attachment allowing you to minimize the footprint of the roadway during road transport.
3-point arch with rotation system. When the tractor is forced to travel on a route with sudden changes in slope, the rotation of the bow prevents the shredder from being crushed towards the ground, limiting compensation with the lift.
The rotation system with double connecting rod allows for a range of configurations from the vertical position up to an inclination of approximately 53 degrees downwards with respect to the horizontal direction.
Transmission made with a gearbox and belts of adequate section to support heavy loads.
Rear door adjustable in two positions and removable for easy maintenance.
Front protection with steel strips. Rear support roller with roller scraper adjustable in height in 4 positions.
Rotor can be equipped with knives for greater shredding capacity and lower power requirement. Rotor can be equipped with hammers to safely tackle branches and shrubs up to 80 mm in diameter.
Via dei Carrai, 16, 06019 Umbertide PG, Italia
and then Add to home screento install the Intractor app on your