Replaceable and adjustable anti-wear skid in three positions to vary the cutting height.
Three-point hitch In cat. I and cat. II.
Hitch with 330mm lateral translation. The translation is manual with stop in 6 different positions.
Hitch in “double pull” version: the machine can be installed on both the rear and front lift without having to change the machine configuration.
Front protection with steel strips. Rear support roller with height-adjustable scraper.
Transmission made with gear box and belts, possibility of inverting the pulleys for operation at 540 rpm or 1000 rpm.
Rotor can be equipped with knives for greater shredding capacity and lower power requirement. Rotor can be equipped with hammers to safely tackle branches and shrubs up to 60mm in diameter.
Hammer, triple knife.
The rear idle roller can be configured in 6 distinct positions, which allow you to vary the volume and geometry of the box. There are three height positions away from the rotor (to increase the cutting volume) and three height positions near the rotor (to decrease the cutting volume), this allows you to configure the machine according to the quantity of material to be cut (and therefore the power required) and the size you want to obtain.
Related products
Via dei Carrai, 16, 06019 Umbertide PG, Italia
and then Add to home screento install the Intractor app on your